Twist a thin coin between the two halves of the transmitter near the key ring. Upshifts into Overdrive can be made by shifting to D5. This is done by using added sensors that compare the steering inputs from the driver with the actual motion of the vehicle. However, this does not mean that the Lincoln brand is immune to faults developing with their cars. If you do not use the proper fuel filler cap, excessive pressure or vacuum in the fuel tank may damage the fuel system or cause the fuel cap to disengage in a collision, which may result in possible.
If the light fails to illuminate, continues to flash or remains on, have the system serviced immediately. This tone will sound every 10 minutes until you refuel. When the vehicle key is inserted into the ignition, the steering column will automatically unlock. Additional frontal weight may be added to the front axle reserve capacity provided you limit your payload in other ways i. To remove the floor mat, reverse the installation procedure. Press the control again to return to the playing media.
It will be necessary for your dealer to reprogram all the remote transmitters to your vehicle while performing this service. If no fuel leak is apparent, reset the fuel pump shut-off switch by pushing in on the reset button. Set the fan speed to High 5. Release the key as soon as the engine starts. Within seven seconds of the safety belt warning light turning off, buckle then unbuckle the safety belt. While the light is illuminated, press control 1. Use of an engine block heater is strongly recommended if you live in a region where temperatures reach -23°C -10°F or below.
Displayed when the electrical system is not maintaining proper voltage. When the key is inserted into the ignition switch, the column will return to the previous setting. The adjustment screw is located on the outboard side of the headlamp. H C Never remove the coolant reservoir cap while the engine is running or hot. Failure to do so may damage the transmission. You should drive in a moderate fashion avoid heavy acceleration and deceleration and have your vehicle serviced at the first available opportunity. The following are reasons most often given for not wearing safety belts: All statistics based on U.
This step will program your new key to a coded key. In order to increase the airflow to the outer panel vents, close the central panel vents. Over time the adaptive learning process will fully update transmission operation to its optimum shift feel. Position the seat, mirrors and steering column to the positions you desire. If there is difficulty in turning the key, firmly rotate the steering wheel left and right until the key turns. Use a load carrying hitch.
Never place your arm over the air bag module as a deploying air bag can result in serious arm fractures or other injuries. This feature enables the audio playing media to continue playing up to 10 minutes after the ignition has been turned off, or until a door is opened. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from for that seating position until. Exposure of people or animals to these high temperatures for even a short time can cause death or serious heat-related injuries, including brain damage. The horn will chirp to confirm that the control was pressed. A correct zone setting will eliminate this error.
To lower the shoulder belt height, push the button and slide the height adjuster down. Never drive through water that is higher than the bottom of the hubs for trucks or the bottom of the wheel rims for cars. Rather, it means the forces were not of the type sufficient to cause activation. Unless serviced, the system may not function properly in the event of a collision. Safety belt pretensioner Your vehicle is equipped with safety belt pretensioners at the driver and front passenger seating positions. Key information Your vehicle is supplied with three coded keys two master keys and one gray valet key.
This feature is designed to increase durability, and provide consistent shift feel over the life of the vehicle. Rotate control in the opposite direction to disengage childproof locks. Place the positive + side of new battery in the same orientation. If you are operating electrical accessories when the engine is idling at a low speed, turn off as many of the electrical loads as soon as possible. Ensure the mirror is pulled down low enough to prevent visibility interference with the overhead console. Make sure the vehicle is on level ground.
Make sure the parking brake is fully set. The HomeLinkt Universal Transceiver has now been trained to the receiver. There are hundreds of files to guide the users but saving these files in your Smartphone will never hang your system. To stop on a particular selection, press the control again. Always ensure that the weight of passengers, cargo and equipment being carried is within the weight limitations that have been established for your vehicle including both gross vehicle weight and Front and rear gross axle weight rating limits.