However, the air cannot be cooled below the outside temperature because the air conditioning does not operate in this mode. Press the H or M control to engage the clock at this time. If the light fails to illuminate, continues to flash or remains on, have the system serviced immediately. If you drive up or down a steep hill, your vehicle speed may vary momentarily slower or faster than the set speed. For information on the safety belt minder chime, refer to the Seating and safety restraints chapter. To unfasten, push the release button and remove the tongue from the buckle. Turn control to raise or lower volume.
The magazine may be stored in the glove box when not being used. The childproof locks are located on rear edge of each rear door and must be set separately for each door. The rear doors can be opened from the outside when the doors are unlocked. Refer to Engine oil in the Maintenance and care chapter. Refer to Lubricant specifications in the Capacities and specifications chapter. To stop on a particular selection, press the control again. Adults are advised to familiarize themselves with the operation and location of the release handle.
Driving with the parking brake on will cause the brakes to wear out quickly and reduce fuel economy. ² A special seat cover designed to allow airbag deployment. Illuminates when the oil pressure falls below the normal range. Turn off the ignition whenever you leave your vehicle. Heating and air conditioning capabilities are provided in this mode. Once the windshield has been cleared, operate the climate control system as desired.
Refer to the Traction Control section of the Driving chapter for more information. Do not shift the gearshift lever into N Neutral with the speed control on. Confirmation of disabling Belt Minder is provided by flashing the safety belt warning light four times per second for three seconds. It may take a long period of time for the system to detect an improperly installed fuel filler cap. .
If you wish to maintain your preset volume level, turn the audio system off with the power control before switching off the ignition. It also illuminates when the Traction Control y system begins applying and releasing the brakes and adjusting the engine characteristics to limit a wheelspin condition. Hold the control to continue reversing through the disc. Press and hold a memory preset control until the sound returns, indicating the station is held in memory on the control you selected. Important ventilating information If the engine is idling while the vehicle is stopped in an open area for long periods of time, open the windows at least 2.
To set the minute, press and hold the minute M control. Never wear the shoulder belt under the arm. Hold the control to fast-forwardthrough the remaining discs. Seating and safety restraints Do not put anything on or over the air bag module. Failure to replace the Belt and Retractor assembly could increase the risk of injury in collisions. Power steering uses energy from the engine to help steer the vehicle. Insert the tongue into the proper buckle for your seating position until you hear a snap and feel it latch.
Do not allow people to ride in any area of your vehicle that is not equipped with seats and safety belts. Refer to Bulbs in the Maintenance and care chapter. Press the control to activate and deactivate Dolby t noise reduction. However, the air cannot be cooled below the outside temperature because the air conditioning does not operate in this mode. If a replacement oil filter is used that does not meet Ford material and design specifications, start-up engine noises or knock may be experienced. ² If your vehicle has been parked with the windows closed during warm weather conditions, the air conditioner will perform more efficiently in cooling the vehicle if driven for two or three minutes with the windows open. Install the child safety seat in a seating position which is capable of providing a tether anchorage.
Controls and features 50 Ask a question about the Ford Taurus 2001 Have a question about the Ford Taurus 2001 but cannot find the answer in the user manual? Check the oil level and add oil if needed. Automatic locking mode In this mode, the shoulder belt is automatically pre-locked. Failure to replace the safety belt assembly could result in severe personal injuries in the event of a collision. Correct vehicle usage and the authorized disposal of waste cleaning and lubrication materials are significant steps towards protecting the environment. Press the control to move the seat forward, backward, up or down.